P. (309) 925-7623
BUTT JOINTS
 
Asphalt Butt Joints deform over time and require time-consuming installation. TempRamps won't deform like asphalt and can withstand extended use.

With TempRamps, one person can quickly and easily complete the installation. And, TempRamps last through multiple usages.

Product to Use:
For two 12-foot road widths, use twelve (12) PTR2-48 Ramp Sections or eight (8) TB37 Ramp Sections.
 
DOORWAY RAMPS
 
Uneven concrete at a doorway can create an uncomfortable ride for vehicles and forklifts. Use TempRamps to create a smooth transition and cut down on wear and tear of your forklift tires.

Product to Use:
Use PTR2-29, PTR2-48, TB14, or TB37 Ramp Sections as needed to cover the necessary space.
 
END-OF-DAY JOINTS
 
Create straight, clean end-of-day joints with TempRamps. Lay the ramps down and rake like a permanent joint. Shut off vibrating as you approach the ramps and roll off like any other joint. The next day, remove TempRamps and you have a straight joint to continue your work.

Product to Use:
For two 12-foot road widths, use twelve (12) PTR2-48 Ramp Sections or eight (8) TB37 Ramp Sections.
 
MANHOLES
 
When roadwork is ongoing around existing manholes, TempRamps provide a smooth transition for traffic flow through the area.

Product to Use:
Use Four (4) TM26 Ramp Sections to make a complete manhole ramp.
 
SPEED BUMPS/HUMPS
 
Temporary Speed Bumps and Humps are fastened to the road using structural screws and can be easily moved at any time. This flexibility allows for temporary traffic control at large events or to test potential locations for permanent installation. These temporary traffic measures can effectively slow traffic to 20 miles per hour.

Specifications - Speed Bump:
Total Length: 7'
Length of End Ramp: 3' 6"
Height: 3"
Mats per 3-foot Section: 4
Mats per 24-foot Width: 32
Specifications - Speed Hump:
Total Length: 11'
Length of End Ramp: 3' 6"
Length of Center Stack: 4'
Height: 3.5"
Mats per 3-foot Section: 8
Mats per 24-foot Width: 64
Product to Use:
Use PTR2-29, PTR2-48, or TB37 Ramp Sections as needed to cover the necessary space.
 
STEEL PLATES
 
After placing Steel Plates, just add TempRamps and you are done. No need to mess with putting down and taking up asphalt. And, TempRamps can be used multiple times for all your Steel Plate jobs.

Product to Use:
Use PTR2-29, PTR2-48, or TB37 Ramp Sections as needed to cover the necessary space.